WT is the command to run mutiple scripts in RC??
Please Let me know , if exists any command to run multiple scripts ( 2 scripts) at a time using Selenium RC??
Its a bit [stupid is as stupid does] requirement...
Please reply back..ASAP..
Re: WT is the command to run mutiple scripts in RC
I don't know if there is any command for that..
But yeah selenium-grid will help you in this case. i haven't used it yet so can't tell you more about that..
But have look at that. http://selenium-grid.seleniumhq.org/
Re: WT is the command to run mutiple scripts in RC??
You can run tests in parallel on a single machine if you start multiple Remote Controls.
Use the command and repeat it, changing the port number:
<font class="small">Code:</font><hr /><pre>ant -Dport=1000 launch-remote-control
ant -Dport=1001 launch-remote-control
</pre><hr /> etc.
Grid Hub will then distribute the tests across the available remote controls.
Grid's power comes when you use it to run tests on multiple machines. To do that you need to designate a machine as the Hub and others as the Remote Controls.
You can read all about that here:
It's not as straight forward as it tries to make out though and requires some set up - you need to know how to ping the other machines and ideally configure the Remote Control machines IP addresses. If you know that great, if not post here and I'll rant on.