Setting up the load test
When creating a load test scenario, it appears I can set the following values to run the test:
Virtual Users: 1 Test for 1 minute
Virtual Users: 2 Test for 1 minute
Virtual Users: 4 Test for 1 minute
This implies that I'm going to run each user continually for a minute. I’m assuming here that this will run the test for each virtual user continually for a minute ~ even if there is only one test to run?!
I have run a simple login load test for one user with only one set of login data and this performed the test 7 times.
Is there a way of just being able to run this test once for one virtual user, or twice for two consecutive users without it running multiple times for the duration of a minute? I.e. 1 user will run the test once, two users will run the test twice simultaneously, three users will run the test simultaneously three times etc etc…. Rather than having two users running the test simultaneously over and over again for a minute….. Or am I misunderstanding this setup?!
Re: Setting up the load test
Basically and simply, you enter 0 within the "test for 'x' minute(s)".
Virtual Users: 4 Test for 0 minute
will simply run the test four times (one for each user)