I have the below scenario using Neoload:
I have two populations:
Population1 has 25 Virtual Users
Population2 has 25 Virtual Users
Two Load Generators:
Now I want Population1 to take the IPs and run from locahost and Population2 to take the IPs and run from 10.104.42.100.
Is there any way that this can be achieved?
can this be achieved on any other tools?
Help and support much appreciated.
What has your research and training on Neoload suggested to you about this setup?
Replace ineffective offshore contracts, LoadRunnerByTheHour. Starting @ $19.95/hr USD.
Put us to the test, skilled expertise is less expensive than you might imagine.
Twitter: @LoadRunnerBTH @PerfBytes
If you want to run both populations at the same time, you should have only one scenario with the two populations inside.
1. Select your population1
2. Set your load policy and select the load generator localhost. Uncheck 10.104.42.100 if it's selected.
3. Do exactly the opposite for the population2
Each population will use the selected load generator during the test.
Hope this helps,
Neotys, Make sure it works!