I've met another confusing situation. I made the script that logging into
the system and then blabla....
I didn't use data bank (login/password)for logging in, so I tried to use "Parameters" values on the first page (In the hierarchy, under the Address of the page there is Parameters option) . And it worked fine for some time... but at some point of
testing Well, i'm trying to figure out when does it happen, the
parameters disappear from the hierarchy and it can't login... since no
Well, the problem is solved by simply closing and opening the script, but anyway, it happened 2nd time already and it's interesting for me...
Check the properties for each of the parameters you have set. Do any of these have the "Use Default Values" checkbox checked?
If so, your script will run perfectly well the first time that you run it but then will accept default values instead when you run it a second time. It is also maybe possible that when you reload the script and run it again the first time it will take your original parameter settings and use them.
If that isnt it then I am stumped for another idea... but I will think about it.
"Not every solution was derived to address an obvious problem" - Me (quite recently indeed)