| || |
I am new to OpenSTA.
I have recorded a simple scenario, where in a user logins and creates a patient in the application. ( patient is created by entering some relevant data)
When I test this scenario for Vusers load = 1 the test start running and completes successfully. But, when I increase this Vuser load = 10 the test start running but never stop. (waited for more than 30 min) then I explicitly stopped this test by clicking on “Kill test” button.
Further to this
“E* Connection ERROR for 102. Error is 10048: (Only one usage of each socket address (protocol/network address/port) is normally permitted. )” error message is displayed in audit log report.
Further in Test error log report following error message is displayed “ERROR 10048: (Only one usage of each socket address (protocol/network address/port) is normally permitted. ) for VU 2-3 while establishing connection 2/102.”
Please let me know if some more data is required on this.
Please let me know how to come over this error/ problem. Also let me know if I have let-out anything.