Recovery Scenario and Error Message Pop-up
I currently have a recovery scenario that calls a function on any run error. My recovery function then sends out an email notifying me that there was an error. After the recovery function is ran it returns to the test and continues running. However, I would like the Error Message Pop-up (that occurs if you do not use recovery scenario) to still pop-up at the end of the recovery function. This way, when I get the email I can go back to this PC and see the error detail as well as enter debug mode. If I cannot get the Error Message Pop-up I will be okay as I can put the info I need in a msgbox. The main concern is that I want the test to enter debug mode after my recovery function runs. I have tried "Stop" and it works in my test but not in my function.