I just upgraded to QTP 10 and QC 10. Recently, I noticed that QTP was having some problems getting connected to QC at startup. Specifically, when I'd start QTP, I'd get the following warning:
Initializing Connection Failed.
There is a details button for this message, but it is disabled so I can't get better info out of it.
Once I clear the message, QTP continues to load.
If I close QTP and start over again, then it is able to connect to QC and load without issue.
Has anyone else had this occur? If so, how have you addressed it, if at all?
Not at the table, Carlos!