Suppose I have a for oop iteration (for i=1 to 100).
If i=5, I want to stop this current iteration and go to next round iteration (i=6) immediately. Do you know which command I can use?
Check QTP help for syntax..
Just don't forget that exiting an iteration in the middle can be messy.
If each of your iterations logs in, does something, then logs out, and during iteration 5 you log in then exit the iteration without logging out, iteration 6 might blow up when it tries to log in.
So just make sure that before you exit the iteration in the middle, perform whatever steps you need to get the AUT into it's ready state to begin the next iteration.
"The last 10% of any software project will take 90% of the budgeted time. The first 90% will take the other 90%"