After running Winrunner scripts from Testdirector, I am unable to view my test results. The test results page loads up however is blank. Is there anything I need to set within Test Director or Winrunner to enable this?
Are you talking about the normal test results that you see in WR or the ones in TD? I would double check all of the steps in the manual that you did to make your connection to make sure that you did everything and that everything is still the way you set it. (This includes the client side setups that you run for TD on your client PC).
It might also be helpful if you posted the versions of TD & WR that you are using....
Quality is the result of a carefully constructed cultural environment. It has to be the fabric of the organization, not part of the fabric.
first check the test results in WR only if you are able to see there then check it in TD Test LAb tab. You will get the results in TD when you are running the test case in run mode only from test run tab
you wont see any results in TD if you are opening the script from TD and then running the test case from WR. then results will be only in WR
I am using WR v7.6 and TD 7.6. The test results I am referring to are the Winrunner results which can be brought up through TD within the test run properties in the Test Lab. Results can be viewed fine from within WR, and scripts can be executed remotely through TD. The step names are successfully displayed also. But still no results! Any suggestions?