| || |
ddt_set_val_by_row not functioning as expected
I was trying to write to an xls sheet using the command "ddt_set_val_by_row" but I recieved the error -10005 (parameter out of range). I had created the xls sheet externally and it contains 4 columns. I have also added the ddt_save value after the command ddt_set_val_by_row.
Is there any workaround for this.
Any help would be appreciated.
Re: ddt_set_val_by_row not functioning as expected
1.Check out whether the table is in READWRITE mode.
2.If You are using ddt_set_row note that it points to the active row ie 1st row.
3.Try to increase the rows in the table atleast blank and then try to set the val.[just for verification]