getting test name pausing it and then resume
There is a situation where I need to pause the test under execution, do processing on some other application using another winrunner function and then resume the test which was paused. Is this possible and how.
Re: getting test name pausing it and then resume
why do you need to pause the test. If at a certain point your test needs to do some work on another application simply call the function from the same test
However I need to do this as I am passing control over to another automation tool that does some work on another application so that way I do it is as follows.
1) Using an access table I set the a value in a column to "Function 1"
2) Run both functions at once. Function 1 will do some work but Function 2 keeps on polling the table and will not continue until it says "Function2"
3) When function one is at the point where it needs the application it sets the value to "Function2"
4) Function 2 does some work and at the end will set the value back to "Function1" and function 1 will set off again.
Hope this helps